Skip to main content

Category

Swann Power Supplies

6 products

Swann power supplies

Find the power supply that fits your Swann

Match the volts, amps and plug on your old adapter's label. Swann NVRs run on 48V and DVRs and coax cameras on 12V, so the two are never interchangeable.

See all Swann power supplies (6)

  • Matched to Swann's original ratings
  • Australian-approved adapters
  • Not sure? We'll check your label

Which power supply fits my Swann?

Find your recorder's model, then check the volts, amps and plug match your old adapter.

Which power supply fits my Swann?
Your Swann PlugRating Power supply
NVR 8-channel NVR8-8580, 8580RN, 8780, 8600 SWNVR-88580H Round 4-pin 48V 1.5A Most popular Swann 48V 1.5A 4-pin NVR power supply $ 122.50
NVR 16-channel NVR16-8580, 8580RN NVR-168580 Round 4-pin 48V 3.75A 16Ch recorders Swann 48V 3.75A 4-pin NVR power supply $ 168.00
NVR 4 & 8-channel NVR-7300, 7400, 7285 Adapter GQ90-480187-E1 Barrel, centre pin 48V 2A 48V 2A NVR power supply $ 75.40
DVR 4 & 8-channel Swann DVRs Label reads 12V 2A 2.1mm barrel 12V 2A Most popular Swann 12V 2A DVR power supply $ 26.50
DVR 16-channel DVR16-5580, 4980, 4680, 4580 Adapter CS-1205000 2.1mm barrel 12V 5A 12V 5A 16-channel DVR power supply $ 46.95
Cameras Up to 4 analogue cameras Includes 4-way splitter 2.1mm barrel 12V 2A Most popular Swann 12V 2A supply + 4-way splitter $ 28.50

Powering coax cameras

Swann power supply questions

Can I use a generic power supply on my Swann NVR?

Only if the voltage, current and plug all match the original. Swann NVRs run on 48V and also power every camera over PoE, so an under-rated adapter causes reboots and cameras dropping out. The supplies on this page are matched to the original rating.

My recorder keeps restarting or cameras drop out. Is it the power supply?

Often, yes. Ageing or under-rated adapters sag under load, especially at night when the cameras switch on infrared. Check the label rating against the chart above.

Does a 16-channel recorder need a bigger supply?

Yes. The 16-channel NVR16-8580 needs the 48V 3.75A supply, and 16-channel Swann DVRs need 12V 5A. The smaller 8-channel adapters will not run them reliably.

How many cameras can one 12V 2A supply run?

Usually up to four analogue cameras through a splitter, as most draw 200 to 500mA. Cameras with strong infrared or long cable runs are best on their own adapter.

I can't find my model. Can you help?

Yes. Email a photo of the label under your recorder and the label on your old adapter to [email protected] and we will confirm the right part before you order.

INFRONTTECH Promotional Banner INFRONTTECH Promotional Banner INFRONTTECH Promotional Banner

Need help choosing?

Tell us about your property and we'll recommend the right cameras and recorder.

07 5609 4910

Sydney 02 8814 6008
[email protected]

Mon–Fri, 9am–5pm AEST

Product added to wishlist