Category
Swann cables & accessories
Run a camera further, power more cameras from one adapter, or replace a lost mouse. Everything here suits Swann DVR and NVR kits.
For Swann IP cameras on an NVR: one cable carries power and video. Measure the route through the walls and roof, then add a couple of metres.
For Swann coax cameras on a DVR. One 2A adapter and a splitter runs up to four cameras.
Split one 12V adapter between several cameras. Standard 2.1mm plugs.
Genuine 4-pin adapters for Swann 8580 NVRs. Check the chart if you're not sure which.
Swap a failed drive, add storage, put the recorder on Wi-Fi or replace the mouse.
Up to 100m from the recorder to the camera, which is the limit for network cable carrying power (PoE). Our ready-made cables go up to 80m.
Yes, with the inline joiner. Keep the join somewhere dry, such as inside the roof or a camera junction box, as the joiner itself is not waterproof.
No. Cat6 cable is for Swann IP cameras on an NVR. Coax cameras on a DVR use the cable that came with the kit, plus a 12V power supply.
Usually up to four analogue cameras through a splitter, as most draw 200 to 500mA. Cameras with strong infrared or long cable runs are best on their own adapter.
No. Footage lives on the old drive. After you fit the new drive the recorder formats it and starts recording again. Your cameras, settings and app access stay on the recorder.
Need help choosing?
Tell us about your property and we'll recommend the right cameras and recorder.
07 5609 4910Sydney 02 8814 6008
[email protected]
Mon–Fri, 9am–5pm AEST
